DPCAV
GUARDIAN 2D/3D INERTIAL STABILIZER (STANDALONE MODEL)
| Instruction Manual | Click Me! |
| PC Software | Click Me! |
Q: Why do I need the Guardian?, The Guardian helps both beginner and expert pilots fly with confidence, and provides two key modes of operation: In 2D flight mode, the Guardian provides much smoother flight and wing leveling stabilization for your model, which makes it a lot easier to adjust and fly your plane. The Guardian "remembers" level flight for your model and returns it to level flight when needed, as well as providing precise "fly by wire" control., The Guardian has two submodes for 3D flying: In 3D Heading Lock submode, simply center your sticks to have the Guardian lock onto your present attitude (pitch, roll, and heading), which can make it easier to perform stunts like prop hanging, inverted flight, knife edges, low speed harriers, etc. In 3D Gyro submode, the Guardian uses its built-in 3 axis gyro to increase your model’s stability, while leaving you in full control. In this mode the Guardian greatly reduces the effects of gusts, turbulence, motor torque and other factors, and can expand the maneuverability of your model in a variety of conditions., Q: I Fly FPV. Is the Guardian for me?, Q: Will the Guardian work with my model?, Q: How do I install the Guardian?, Q: How do I configure the Guardian?, Q: How does the Guardian work?, Q: What sets the Guardian apart from other Stabilization systems out there?, *Note: Using the PC software will require a common Micro-USB cable. Most likely you already have one of these, but it not then they are available from your local electronic/computer store.,
Based on Eagle Tree's proven inertial stabilization technology, the Guardian ...DPCAV
EAGLEEYES FPV STATION / ANTENNA TRACKING CONTROLLER
| Antenna Tracking | When used with the |
| Instruction Manual | Click Me! |
| Full details / Mfg's web site | Click Me! |
Features:, , Telemetry:, When coupled with the, Receiver Diversity:, When you connect two composite NTSC or PAL video receivers (not included), the EagleEyes constantly picks the better signal. This can greatly reduce video fades and improve your video image. A variety of settings are configurable with the on-board switches and LED indicators., Channel A/V Distribution:, Ever wish you had more video/audio outputs? The EagleEyes has four built-in outputs!, Programmable Low Voltage Alarm:, A low voltage alarm buzzer alerts you when your ground station battery voltage is too low. The buzzer can also be programmed to alert for other conditions, such as poor telemetry signal., Convenient Voltage Requirements:, EagleEyes operates on 6-14VDC (compatible with 3S LiPO batteries). The power inlet is a standard 2.1mm barrel jack. It is capable of powering high torque R/C type pan and tilt servos.,
The EagleEyes® FPV Ground Station combines antenna auto-tracking, receiver diversity, ...DPCAV
SMA CONNECTOR, STRAIGHT PLUG, PCB
| Please note | Construction details to this great performing (and easy to build) patch antenna are found here |
| Dimensional drawing | Click Me! |
, GP Patch Antenna Project: *,
SMA plug connector with four post PCB mounting. This hard-to-find ...DPCAV
900MHZ A/V TRANSMITTER, 1000MW
| USA model has one RF channel | 910MHz (FCC imposed restriction). |
| USA Model Instruction Manual | Click Me! |
| Non-USA Instruction Manual | Click Me! |
Non-USA model has four RF channels:, 910MHz, 980MHz, 1010MHz, 1040MHz, Important note: The DC input connector is a 2.1mm barrel style connector that is center (+) positive. Reversed voltages will damage the receiver., Notice: Due to its high RF power, using the TX9-1000 in the USA and other countries will require an amateur/ham radio license (some countries may forbid its use). It is your responsibility to ensure that its use meets the requirements imposed by your government’s RF spectrum regulations. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them., We offer 900MHz A/V receivers that work great with this transmitter. So if you don't already have a compatible receiver then be sure to check them out:click here,
This 900MHz / 1 Watt (1000mW) wireless A/V transmitter is ...DPCAV
900MHZ PRO-SERIES A/V TRANSMITTER, 500MW
| USA model has one RF channel | 910MHz (FCC imposed restriction). |
| USA Model Instruction Manual | Click Me! |
| Non-USA Instruction Manual | Click Me! |
| Help! What else do I need? | Click Me! |
| 900MHz EMI/RFI Information | Click Me! |
For convenient installation, the TX905-PRO has a JST female power cable (compatible with several of our 3-cell LiPO batteries) and servo-style connectors on the camera and microphone cables. We've made it as ready to use as we could. Just add your compatible camera, battery, and A/V receiver (not included). Plus, a variety of optional accessories are available to make your installation as simple as possible:Click Me!, We also offer high quality 900MHz A/V receivers that work great with this transmitter. So if you don't already have a compatible receiver then be sure to check them out:click here, Non-USA (export) model has four RF channels:, 910MHz, 980MHz, 1010MHz, 1040MHz, Notice: Due to its high RF power, using the TX905-PRO in the USA and other countries will require an amateur/ham radio license (some countries may forbid its use). It is your responsibility to ensure that its use meets the requirements imposed by your government’s RF spectrum regulations. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them.,
We've raised the bar again! This 900MHz wireless video transmitter ...DPCAV
900MHZ A/V TRANSMITTER, 500MW
| USA model has one RF channel | 910MHz (FCC imposed restriction). |
| USA Model Instruction Manual | Click Me! |
| Non-USA Instruction Manual | Click Me! |
Non-USA model has four RF channels:, 910MHz, 980MHz, 1010MHz, 1040MHz, Important note: The DC input connector is a 2.1mm barrel style connector that is center (+) positive. Reversed voltages will damage the receiver., Notice: Due to its high RF power, using the TX9-500 in the USA and other countries will require an amateur/ham radio license (some countries may forbid its use). It is your responsibility to ensure that its use meets the requirements imposed by your government’s RF spectrum regulations. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them., We offer 900MHz A/V receivers that work great with this transmitter. So if you don't already have a compatible receiver then be sure to check them out:click here,
Don't let the small size of this 900MHz wireless A/V ...DPCAV
1.3GHZ A/V TRANSMITTER, 300MW
| USA model has one RF channel | 1280MHz (FCC imposed restriction). |
| USA Model Instruction Manual | Click Me! |
| Non-USA Instruction Manual | Click Me! |
Non-USA model has four RF channels:, 1240MHz, 1280MHz, 1320MHz, 1360MHz, Important notes: The DC input connector is a 2.1mm barrel style connector that is center (+) positive. Reversed voltages will damage the receiver. NEVER operate the transmitter without an antenna or it may be damaged and warranty voided. Please see the instruction manual for more information., Notice: Due to its high RF power, using the TX13-300 in the USA and other countries will require an amateur/ham radio license (some countries may forbid its use). It is your responsibility to ensure that its use meets the requirements imposed by your government’s RF spectrum regulations. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them., We offer a 1.3GHz A/V receiver that works great with this transmitter. So if you don't already have a compatible receiver then be sure to check it out:click here,
Don't let the small size of this 1.3GHz wireless A/V ...DPCAV
WIRELESS VIDEO TRANSMITTER & OSD, FPV DEAL
| Item A | EagleTree eLogger V4 with 100 Amp sensor. |
| Item B | USB cable for eLogger firmware updates. |
| Item C | Eagle Tree OSD Pro Video Expander module. |
| Item D | GPS extension cable for kits shipped before June-2010. |
| Item E | eLogger GPS-V4 Expander module. |
| Item F | Eagle Tree OSD Pro cable Kit. |
| Item H | DPC-420A 420 line CCD color camera. |
| Item I | DPC-420A/480A camera interconnect cable. |
| Item J | TX9-500 900MHz / 500mW transmitter. |
| Item K | Dipole Antenna, +3dBi omni-directional. |
| Item L | Deluxe A/V cable for TX9-500 transmitter. |
| Item M | Male-male video adapter cable, |
This wireless OSD system will transmit graphic data and voice announcements that report a variety of alarms and data, including: voltage, current, mAH, Watts, Home Arrow, Return to Home (RTH / RTL), RADAR, altitude, course (travel direction), ground speed, longitude, latitude, and navigation waypoints. You can expand this system even further by using the low cost eLogger accessories, such as these:Click Me!, Here's a screen shot that shows some of the information that can be shown (temperature and RPM data requires optional accessories):, , All the data parameters that are supported by the eLogger can be displayed on the video display. Here are some examples:, , Notice: Due to the 900MHz transmitter's high RF power, using it in the USA and other countries will require an amateur/ham radio license (some countries may forbid its use). It is your responsibility to ensure that its use meets the requirements of your government’s RF spectrum regulations. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them., . We have other battery choices so that you can select the best one for your application. More choices:Click Me, (3) The 900MHz A/V receiver is not included, but we offer fully compatible models that work great with this special package. Please look here to purchase them:click here, The video format is available in NTSC or PAL. If you are unsure which to choose then please consult this list:TV Video Standards., ,
Ok, so you've decided that you need the EagleTree OSD ...DPCAV
FY-30A PRO R/C INERTIAL STABILIZER SYSTEM
Sold Out:, No longer available., How it works:, , Applications:, , The FY30A can be used in the following fixed wing models:, , Compare FY-30A to FY-20A:, Click Me!, Instruction Manual:, Click Me!, Firmware Update Instructions:, Click Me!, Firmware V1.20 Upgrade Files:, Click Me!, Firmware PC Application:, Click Me!, Manufacture's web site:, Click Me!, Sold Out:, No longer available.,
But don't worry, we now offer a lower cost replacement ...DPCAV
HIGH PASS ANTENNA FILTER FOR 2.4GHZ TX
Features / Specifications:,
This High Pass Filter is designed to attenuate radiated EMI/RFI ...DPCAV
ELOGGER V4 WITH WIRE LEADS, 150 AMP SENSOR
| Instruction Manual | Click Me! |
| Manufacture's Web Site | Click Me! |
Specifications:, Logs battery current to +/- 150 Amps, .035A resolution.,
Whether you’re into robotics, R/C models or Ham radio ATV, ...DPCAV
ELOGGER V4 WITH WIRE LEADS, 100 AMP SENSOR
| Instruction Manual | Click Me! |
| Manufacture's Web Site | Click Me! |
Specifications:, Logs battery current to +/- 100 Amps, .02A resolution.,
Whether you’re into robotics, R/C models or Ham radio ATV, ...DPCAV
ELOGGER V4 WITH CONNECTORS, 100 AMP SENSOR
| Instruction Manual | Click Me! |
| Manufacturer's Web Site | Click Me! |
Specifications:, Logs battery current to +/- 100 Amps, .02A resolution.,
Whether you’re into robotics, R/C models or Ham radio ATV, ...DPCAV
5.8GHZ CLOVERLEAF ANTENNA, RHCP
| Center Frequency | 5.8GHz |
| RF Bandwidth | 120MHz |
| Gain, 3-lobe | ~1.2dBiC |
| Beamwidth | 360° omni |
| Polarization | RHCP |
| RF connector | SMA Plug |
| Height | 1.2 inch |
| Width | 1.2 inch |
| Weight | 4.4g |
| REFERENCE PLOTS | ANTENNA RF PATTERNS |
Manufacture:, Aerial Video Systems, Important: To ensure RF performance do NOT add paint or coat the element lobes (leave the factory applied finish as-is). The elements should not be allowed to rest against any structures. Do not bend or deform the elements., NOTE: Some FPV model installations may need an extension to ensure the antenna is away from nearby surfaces.,
The 5.8GHz Cloverleaf antenna is circularly polarized (RHCP) and designed ...DPCAV
SMA EXTENSION CABLE, RG-316/U COAX, SHORTY
SPECIFICATIONS:,
RG-316/U coaxial extension cable, 2.4-inches (60mm) long. High quality SMA ...